Multiple DVPST_point's not supported ?

All other questions regarding DICOMscope

Moderator: Moderator Team

Post Reply
Message
Author
LarsKlitgaard
Posts: 3
Joined: Mon, 2010-06-28, 15:55

Multiple DVPST_point's not supported ?

#1 Post by LarsKlitgaard »

Using graphicObject.setGraphicType(DVPST_point) and having multi datapoints (X1\Y1\X2\Y2\X3...) in my GSPS causes DicomScope to display only the first dot. If I use polyline I see the full number of dots/lines.
I believe this is a limitation to DicomScope ?
Thanks for a great collection of tools and for a great forum.
Lars Klitgaard, Denmark

Jörg Riesmeier
ICSMED DICOM Services
ICSMED DICOM Services
Posts: 2217
Joined: Fri, 2004-10-29, 21:38
Location: Oldenburg, Germany

#2 Post by Jörg Riesmeier »

No, it is a limitation of the DICOM standard (if you like :-). Here's the relevant excerpt from PS 3.3-2009 section C.10.5.1.2:
If Graphic Type (0070,0023) is POINT, then two values (one point) shall be specified and the single point specified is to be drawn.

LarsKlitgaard
Posts: 3
Joined: Mon, 2010-06-28, 15:55

My fault

#3 Post by LarsKlitgaard »

Thanks a lot for a fast and precise answer. My fault. I am using the 2007 revision of the DICOM standard and can confirm that the exact same sentence is in that version as well.
Sorry and thanks again :-)
Lars

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest